Connecting to Prime locally without a router | D-D The Aquarium Solution

To set up the Prime with the iOS app:

1. Plug in power to the Prime

2. Wait a minute until the Prime's indicator light start flashing blue/green or flashing green.  If the Prime does not do this, hold the button down on the Prime for 3 seconds until the indicator LED flashes green. Upon release, the network setting on the Prime will be reset.

3. On your iOS device, go to Settings.  Choose the Prime's network in your available WiFi networks.  The network name should be "prime-XXXXXXXXXXXX", where the Xs are the Prime's serial number.

4. Open the myAI app. The app should prompt you to set up the light.  If not, click the "+" at the top of the screen.

5. Enter a tank name, choose any children you would like the Prime parent to control, then skip the wifi setup.

6. The Prime will be added to your device list.  To control it, you must be connected to the Prime's wifi network.

To set up the Prime with Android:

1. Plug in power to the Prime

2. Wait a minute until the Prime's indicator light start flashing blue/green or flashing green.  If the Prime does not do this, hold the button down on the Prime for 3 seconds until the indicator LED flashes green. Upon release, the network setting on the Prime will be reset.

3. Click Add > Prime

4. Choose your Prime from the list.

5. Enter the tank name, choose any children you would like the Prime parent to control, then skip the wifi setup.

6. The Prime will be added to your device list. Any time you choose the Prime in the device list, the app will try to connect to the Prime's access point.