D-D Hanging Wires & AI Feet | D-D The Aquarium Solution

 

Blue Gradient
Find Stockist

Introduction

D-D offer a range of wire and foot mounting options to be used with the Twin and Single Hanging Rails kits or for suspending a single light directly from the ceiling. We generally recommend use of wires rather than the feet as it gives mutch greater adjustment over height and overall positioning of the lights.

Rail Hanging Wire Kit

AI WIRE 03

A stainless wire kit designed to hang the all D-D Hanging Rail Systems.

Each set consists of:

  • 2 x 1.5m hanging wires.
  • 2 x Ceiling mounting attachments (screws not included*)
  • 2 x adjustable sliders for height adjustment.
  • 2 x Y wires with balls on the end to integrate with the hanging rail.

* Screws and attaching fixtures will be required, specific to the particular ceiling construction.

Individual Light Hanging Wire Kit

AI WIRE 05

A stainless wire kit designed to hang individual Aquaillumination LED lights directly from the ceiling. Can also be used to hang multiple lights that are connected with the AI EXT SYSTEM.

Suitable for HYDRA 52, HYDRA 26, HYDRA, VEGA, SOL

Each set consists of:

  • 2 x 1.5m hanging wires.
  • 2 x Ceiling mounting attachments (screws not included*)
  • 2 x adjustable sliders for height adjustment.
  • 2 x Y wires with balls on the end to integrate with the hanging rail.
  • 2 x stainless steel plates to connect the wires to the light and to hold them in place.

* Screws and attaching fixtures will be required, specific to the particular ceiling construction.

Rail Mounting Feet

SOL FEET 6

It is possible to mount your D-D Twin Rail Kit directly onto the top of your aquarium or pelmet using this set of 4 plastic feet that slide into a groove on the bottom of the rail.

The length of each foot or leg is 6 inches long and this sets the height of the light above the water. Generally for best coverage from the AI LED lights we would recommend that the units are mounted 10-12 inches above the water surface. This option does work however if you have a pelmet around the tank that further elevates the lights above the water.

Note:

The rail feet are manufactured by AI for a slightly different section of rail and so a little trimming of the plastic foot with a knife is required to make them fit the slot on the D-D profile.